PLANET Swich industrial L3 16 ptos giga PoE+ 4 SFP

Copper Ports 16 10/100/1000BASE-T RJ45 auto-MDI/MDI-X ports

SFP/mini-GBIC Slots 4 1000BASE-SX/LX/BX SFP interfaces (Port-17 to Port-20)

Compatible with 100BASE-FX and 2500BASE-X SFP

PoE Injector Port 16 ports with 802.3at/af PoE injector function with Port-1 to Port-16

Console 1 x RJ45-to-RS232 serial port (115200, 8, N, 1)

Reset Button < 5 sec: System reboot

> 5 sec: Factory default

ESD Protection 6KV DC

Enclosure IP30 aluminum case

Installation DIN-rail kit and wall-mount kit

Connector Removable 6-pin terminal block for power input

Pin 1/2 for Power 1, Pin 3/4 for fault alarm, Pin 5/6 for Power 2

Removable 6-pin terminal block for DI/DO interface

Pin 1/2 for DI 1 & 2, Pin 3/4 for DO 1 & 2, Pin 5/6 for GND

Alarm One relay output for power failure. Alarm relay current carry ability: 1A @ 24V DC

2 digital input (DI) Level 0: -24V~2.1V (±0.1V)

Level 1: 2.1V~24V (±0.1V)

Input load to 24V DC, 10mA max.

2 digital output (DO) Open collector to 24V DC, 100mA max.

LED Indicator System:

 Power 1 (Green)

 Power 2 (Green)

 Fault Alarm (Red)

 Ring (Green)

 Ring Owner (Green)

 DIDO (Red)

Per 10/100/1000T RJ45 PoE+ Ports:

 PoE-in-Use (Amber)

 LNK/ACT (Green)

Per SFP Interface:

 100 LNK/ACT (Amber)

 1G/2.5G LNK/ACT (Green)

Dimensions (W x D x H) 84 x 107 x 152 mm

Weight 1550g

Power Requirements Dual 48~56V DC (>51V DC for PoE+ output recommended)

Power Consumption Max. 15.68 watts/53.46BTU (Power on without any connection)

Max. 344 watts/1173.04BTU (Full loading with PoE function)

Switching Specifications

Switch Fabric 52Gbps/non-blocking

Switch Architecture Store-and-Forward

Throughput (packet per second) 38.6Mpps@ 64 bytes packet

Address Table 32K entries, automatic source address learning and aging

Shared Data Buffer 32Mbits

Flow Control IEEE 802.3x pause frame for full duplex

Back pressure for half duplex

Jumbo Frame 10K bytes

Power Over Ethernet

PoE Standard IEEE 802.3at Power over Ethernet Plus/PSE

PoE Power Supply Type End-span

PoE Power Output IEEE 802.3af Standard

 - Per port 48V~51V DC (depending on the power supply), max. 15.4 watts

IEEE 802.3at Standard

 - Per port 51V~56V DC (depending on the power supply), max. 36 watts

Power Pin Assignment 1/2(+), 3/6(-)

PoE Power Budget 48V Power input

 - 240W maximum (depending on power input)

52~56V Power input

 - Single power input: 240W maximum (depending on power input)

 - Dual power input: 320W maximum (depending on power input)

 ?Dual power input must be the same as DC voltage, like dual 56V

PoE Extend Mode Yes, max. up to 160 meters

Max. Number of Class 2 PDs 16

Max. Number of Class 3 PDs 16

Max. Number of Class 4 PDs 10

Layer 2 Function

Port Configuration Port disable/enable

Auto-negotiation 10/100/1000Mbps full and half duplex mode selection

Flow control disable/enable

Power saving mode control

Port Status Display each port’s speed duplex mode, link status, flow control status,

auto negotiation status, trunk status

Port Mirroring TX / RX / Both

Many-to-1 monitor

VLAN IEEE 802.1Q tag-based VLAN, up to 255 VLAN groups

IEEE 802.1ad Q-in-Q tunneling

Private VLAN Edge (PVE)

MAC-based VLAN

Protocol-based VLAN

Voice VLAN

MVR (Multicast VLAN Registration)

GVRP (GARP VLAN Registration Protocol)

Up to 4K VLAN groups, out of 4094 VLAN IDs

Link Aggregation IEEE 802.3ad LACP/static trunk

Supports 10 trunk groups with 4 ports per trunk group

Spanning Tree Protocol IEEE 802.1D Spanning Tree Protocol

IEEE 802.1w Rapid Spanning Tree Protocol

IEEE 802.1s Multiple Spanning Tree Protocol

QoS Traffic classification based, strict priority and WRR

8-level priority for switching

 - Port number

 - 802.1p priority

 - 802.1Q VLAN tag

 - DSCP/TOS field in IP packet

IGMP Snooping IPv4 IGMP (v1/v2/v3) snooping, up to 255 multicast groups

IPv4 IGMP querier mode support

MLD Snooping IPv6 MLD (v1/v2) snooping, up to 255 multicast groups

IPv6 MLD querier mode support

Access Control List IP-based ACL/MAC-based ACL

Up to 123 entries

Bandwidth Control Per port bandwidth control

 Ingress: 500Kb~1000Mbps

 Egress: 500Kb~1000Mbps

Layer 3 Function

IP Interfaces Max. 128 VLAN interfaces

Routing Table Max. 128 routing entries

Routing Protocols IPv4 hardware static routing

IPv6 hardware static routing

IPv4 OSPFv2 dynamic routing

Management

Basic Management Interfaces Console; Telnet; Web browser; SNMP v1, v2c

Secure Management Interfaces SSH, TLS, SSL, SNMP v3

SNMP MIBs RFC 1213 MIB-II

IF-MIB

RFC 1493 Bridge MIB

RFC 1643 Ethernet MIB

RFC 2863 Interface MIB

RFC 2665 Ether-Like MIB

RFC 2819 RMON MIB (Groups 1, 2, 3 and 9)

RFC 2737 Entity MIB

RFC 2618 RADIUS Client MIB

RFC 2933 IGMP-STD-MIB

RFC 3411 SNMP-Frameworks-MIB

IEEE 802.1X PAE

LLDP

MAU-MIB

Standards Conformance

Regulatory Compliance FCC Part 15 Class A, CE

Stability Testing IEC60068-2-32 (free fall)

IEC60068-2-27 (shock)

IEC60068-2-6 (vibration)

Standards Compliance IEEE 802.3 10BASE-T

IEEE 802.3u 100BASE-TX/100BASE-FX

IEEE 802.3z Gigabit SX/LX

IEEE 802.3ab Gigabit 1000T

IEEE 802.3x flow control and back pressure

IEEE 802.3ad port trunk with LACP

IEEE 802.1D Spanning Tree Protocol

IEEE 802.1w Rapid Spanning Tree Protocol

IEEE 802.1s Multiple Spanning Tree Protocol

IEEE 802.1p Class of Service

IEEE 802.1Q VLAN tagging

IEEE 802.1ad Q-in-Q VLAN stacking

IEEE 802.1X Port Authentication Network Control

IEEE 802.1ab LLDP

IEEE 802.3af Power over Ethernet

IEEE 802.3at Power over Ethernet Plus

IEEE 802.3ah OAM

IEEE 802.1ag Connectivity Fault Management(CFM)

IEEE 1588 PTPv2

RFC 768 UDP

RFC 783 TFTP

RFC 791 IP

RFC 792 ICMP

RFC 2068 HTTP

RFC 1112 IGMP v1

RFC 2236 IGMP v2

RFC 3376 IGMP version 3

RFC 2710 MLD version 1

RFC 3810 MLD version 2

ITU G.8032 ERPS Ring

ITU-T G.8032 ERPS Ring

ITU-T Y.1731 Performance Monitoring

Environment

Operating Temperature -40 ~ 75 degrees C

Storage Temperature -40 ~ 85 degrees C

Humidity 5 ~ 95% (non-condensing)